Real-time and slots casino delayed-time transmission will normally be initiated from the bottom station by way of DCS channels. The parachute Jettisoned (AE13) sign is initiated when the pilot depresses the CHUTE JETT switch energizing redundant fundamental parachute jettison relays. The acquisition support beacon will operate until it's jettisoned with the adapter equipment part. One of the uhf antennas is located on the adapter tools section and serves the DCS receiver quantity 1, and the acquisition aid beacon or delayed-time telemetry transmitter.
The actual-time telemetry transmitter shall be operating throughout the pre-launch phase of the mission. As the spacecraft goes out of vary the delayed-time telemetry transmitter is turned off and the acquisition aid beacon resumes transmission. The stand-by transmitter is switched to delayed-time transmission by a floor Slots command through a DCS channel (if the STBY Control swap is within the OFF place), or by placing the STBY TM switch to the D/T position.
The stand-by transmitter is switched to real-time transmission by a floor command via a DCS channel (if the STBY TM Control change is within the OFF place), or by placing the STBY TM Control change to the R/T position. During orbit, operation of the telemetry transmitters and Slots online beacons will usually be managed by floor commands via DCS channels.
Lightweight headsets are supplied to be used when the spacesuit helmets are eliminated throughout orbit, or free online slots during postlanding if the helmets or whole spacesuit is eliminated previous to restoration.
The flashing restoration light, Casino slots used during the postlanding phase of the mission, accommodates its own power supply and improves visual spacecraft location. The information sign is in phase with the reference for a logical 1 and 180 levels out of phase with the reference for a logical 0; thus establishing the required requirements for digital data. This places coaxial switch 3 to position 1; thus connecting the quadriplexer to the IN position of the coaxial switch 5. Coaxial change 5 was positioned in place 1 when the ANT CNTL swap was placed within the ANTY place throughout the C-band beacon operation.
The desired antenna usage is obtained by placing the ANT CNTL circuit breaker to the ON place. Input voltage is utilized from the spacecraft important bus via the BEACON-C circuit breaker, Slots online C-RNTY BEACON Control switch and the RNTY place of the ANT 8EL swap.